Description:
ACDelco Silver (Advantage) Bonded Brake Shoes are a quality, high value alternative for General Motors vehicles as well as most makes and models and are backed by General Motors. These bonded brakes deliver strong braking power while reducing noise and vibration. The chamfer angle and vane configuration follow the OE design. Also no machining is required. ACDelco Silver (Advantage) Bonded Brake Shoes are ready to be installed right out of the box. ACDelco Silver (Advantage) parts are a good choice for many vehicles on the road today. Some ACDelco Silver parts may have formerly appeared as ACDelco Advantage. ⚠ WARNING: Cancer and Reproductive Harm - https://www.P65Warnings.ca.gov
Features and Benefits:
- Available in riveted and bonded for various vehicle applications
- Basic shims, slots, and chamfers help to diminish noise, vibration, and braking harshness
- Economical value with dependable quality
- For General Motors vehicles as well as most makes and models
- Non-directional brake surface finish for consistent braking
- Quality validated for proper metallurgy and correct brake plate thickness
- Some ACDelco Silver parts may have formerly appeared as ACDelco Advantage
Specifications:
Brake Drum Diameter:
11.142 in.
Brake Drum Diameter:
283 mm
Brake Shoe Width:
2.756 in.
Drum Inside Diameter (in):
11.16 in
Friction Material Attachment:
Bonded
Mounting Hardware Included:
No
Primary Shoe Friction Material Length (in):
11.2 in
Primary Shoe Friction Material Length (mm):
283.5 mm
Secondary Shoe Friction Material Length (in):
11.2 in
Secondary Shoe Friction Material Length (mm):
283.5 mm
Features and Benefits:
- – Calipers and wheel cylinders should be checked every brake inspection and serviced or replaced as required.
- – Check brake fluid level at every oil change. Replace fluid according to owner's manual recommendations.
- – Inspect the brake lines for rust, punctures, or visible leaks (You may be able to do this, but consult a qualified technician if necessary).
- – Inspection of brake lining and pads for wear or contamination by brake fluid or grease.
- – Inspection of the brake hoses for brittleness or cracking.
- – Inspection of wheel bearings and grease seals.
- – Parking brake adjustments (as needed).
- The following inspections and maintenance procedures can help prevent potential brake problems:
- The following should be conducted by a qualified technician:
Specifications:
Manufacturer Warranty:
12 Months