Brands Vehicles
Lowest Prices
Free Returns
Online Since 2009
Shopping for

2009 Hummer H3T

X

A1 Cardone 65-9492 Drive Shaft
for 2009 Hummer H3T

A1 Cardone 65-9492 Drive Shaft - 2009 Hummer H3T Image 1
A1 Cardone 65-9492 Drive Shaft - 2009 Hummer H3T Image 2
A1 Cardone 65-9492 Drive Shaft - 2009 Hummer H3T Image 3
A1 Cardone 65-9492 Drive Shaft - 2009 Hummer H3T Image 4
A1 Cardone 65-9492 Drive Shaft - 2009 Hummer H3T Image 5
A1 Cardone 65-9492 Drive Shaft - 2009 Hummer H3T Image 6
A1 Cardone 65-9492 Drive Shaft - 2009 Hummer H3T Image 7
A1 Cardone 65-9492 Drive Shaft - 2009 Hummer H3T Image 8
A1 Cardone 65-9492 Drive Shaft - 2009 Hummer H3T

A1 Cardone
Brand:A1 Cardone
Part Number: 65-9492
UPC: 082617857475
Weight: 22 lbs
Condition:New



Availability:
0 in Stock
 OUT OF STOCK

Product Information

Description:

Get the A1 Cardone 65-9492 Drive Shaft for your 2009 Hummer H3T. Buy now and secure your purchase online!

CARDONE Remanufactured Prop Shafts are engineered using the most stringent quality processes to deliver smooth, consistent performance in any driving condition. Original designs are scrutinized for potential improvement, and where applicable, design upgrades are implemented to produce a more durable part than the original. All critical components are tested to ensure proper function. Additionally, all CARDONE Prop Shafts are 100% dynamically balanced, resulting in vibration-free performance at all speeds.

Features and Benefits:

  • 100% NEW universal joints are installed to ensure proper fit and optimal performance.
  • All slip yokes are lubricated to prevent premature wear.
  • Built to match O.E. form, fit and function.
  • Units are 100% dynamically balanced at 3200 RPMs for vibration-free operation and increased joint life.

Specifications:

CV Joints Included:
Yes
Compressed Length:
29.65 in.
Compressed Length:
753.00 mm
Contains Electronic Components?:
No
Drive Shaft Type:
Universal Joint
E-Waste:
No
End 1 Type:
Universal Joint
End 2 Type:
Bolt On
FAA_A1:
The most common causes of prop shaft vibrations are worn joints, an unbalanced drive shaft, poor joint lubrication, and a bent or twisted shaft.
FAA_A2:
Each shaft is precisely balanced before boxing. Prop shaft balance is necessary for proper driveline operation. An unbalanced shaft can cause premature wear on other major components such as your transmission and rear differential.
FAA_A3:
This procedure entails the distribution of mass in the rotating prop shaft. The shaft is measured and altered where necessary to ensure that vibration does not occur during operation.
FAA_A4:
Not all vehicles will have a prop shaft. Prop shafts are most commonly found on all-wheel-drive and rear- wheel-drive vehicles.
FAA_A5:
Phasing is a used to describe the alignment of the yokes with each other at both ends of the prop shaft. The phase angle is the rotational position of each yoke on a prop shaft.
FAA_A6:
A universal joint is designed to allow prop shafts to move with suspension travel while the shaft is moving. This allows power to be transmitted when the prop shaft is angled between the transmission and differential.
Grade Type:
Regular
Greasable:
Yes
Grease Fitting Included:
Yes
Is item a chemical?:
No
Is or contains a battery?:
No
Is or contains a bulb?:
No
Is the item CARB affected?:
No
Package Contents:
Prop Shaft; Instruction Sheet
Phased:
Yes
Pre-Greased:
Yes
Product Condition:
New
SDS Required:
No
Shaft Diameter:
2.00 in.
Shaft Diameter:
51.00 mm
Shaft Material:
Steel
Slip Yoke:
No
Universal Joints Included:
Yes
Hummer #:
10376298
Hummer #:
25859867
Prop 65:
No
Country of Origin:
CN

Manufacturer Warranty:

12 Months

A1 Cardone 65-9492 Drive Shaft compatibility with your 2009 Hummer H3T...

Last Updated: 06/03/2024

Years Vehicle Per Vehicle Position Fit NotesFitment Notes

2010

 

2009

 

2010

 

2009

 
Hummer H3T

3.7L L5 Gas DOHC
1
 
Front
 
Driveshaft / Prop Shaft
with 29.65 (in) Long Driveshaft
Measurement taken from the CV face to the centerline of the furthest U-Joint on the opposite end of the collapsed Prop Shaft
Supplied as New
 

Hummer H3T



3.7L L5 Gas DOHC

Front Driveshaft / Prop Shaft
with 29.65 (in) Long Driveshaft
Measurement taken from the CV face to the centerline of the furthest U-Joint on the opposite end of the collapsed Prop Shaft
Supplied as New

1 Per Vehicle

2009

 

2009

 
Hummer H3T

5.3L V8 Gas OHV
1
 
Front
 
Driveshaft / Prop Shaft
with 29.65 (in) Long Driveshaft
Measurement taken from the CV face to the centerline of the furthest U-Joint on the opposite end of the collapsed Prop Shaft
Supplied as New
 

Hummer H3T



5.3L V8 Gas OHV

Front Driveshaft / Prop Shaft
with 29.65 (in) Long Driveshaft
Measurement taken from the CV face to the centerline of the furthest U-Joint on the opposite end of the collapsed Prop Shaft
Supplied as New

1 Per Vehicle

Didn't find a match for your vehicle?

  See Other Choices