Straight-Blade Hose Cutter Cuts rubber hoses ranging from 1/4" to 1-1/2". Simply place hose in tool and squeeze handle to cut. Replacement steel cutter blade No. 4509-1 is available. No. 4509 Straight blade hose cutter.
Unique tip easily fits between hose and fitting to break stubborn hoses loose Large handle provides a good grip on tool during hose removal Works on radiator hoses, heater hoses, transmission lines any place a rubber hose is clamped to a fitting
Disengages the line from Jiffy-tite quick connect fittings without removal of the clip. Teeth of the tool fit perfectly into tight tolerance of Jiffy-tite connectors and when rotated allow the line to be pulled without damage to the connector or ret…
Clamps and holds hoses up to 3/4" I.D Angled jaws close to create a complete seal every time Jaws are offset for hard-to-reach areas The handles lock firmly to hold the jaws in a closed position Frees both hands to do the work Used on brake hose…
For Easy Removal of 5/32" to 1/2" Vacuum and Fuel Hoses. Engage the tube (line) with the black jaw. This sharpened jaw actually "DIGS" into the tube to grip it! Squeeze and the hose is easily pushed off by the silver jaw.
A super strong extractor set made of a special hardened, shock resistant tool steel. Works on both left and right hand threads. Drill properly sized hole in fastener and drive Super Out Extractor into hole. Super Outs cut their way STRAIGHT into bolt…
Squeeze hose shut, eliminating the need to drain the system when servicing the cooling system Larger levers give ability to close off wire lined hose Pivoting jaws for parallel clamping & locking ratchet mechanism. Made in U.S.A.
1-1/4 OD capacity Patented clamping mechanism locks automatically - no screws or levers to set or adjust Hardened steel pivots for lifetime service Extra-long cushioned hand grips for comfort and control
Great for the removal of rubber hoses from inlets, outlets and clamps. Specially designed end makes hose removal easy. Large, comfortable handle. Hardened and plated shaft. 8 1/2" overall length with 4" exposed shaft.
Removes even the most corroded heater hose couplers on GM vehicles. When the coupler is extremely corroded the special tapered, reverse drill can be used to remove the remaining connector. Then the tap can be used to restore the original threads.