Description:
Get the ACDelco 10388794 Brake Hydraulic Line for your vehicle. Buy now and secure your purchase online!
GM Genuine Parts Brake Hydraulic Lines are designed, engineered, and tested to rigorous standards, and are backed by General Motors. These are quality reinforced lines that carry fluid within the brake system. The hydraulic fluid must travel to the wheel brakes from the master cylinder. It does this through brake lines or pipes and brake hoses. Brake lines and hoses are designed to withstand high pressures. GM Genuine Parts are the true OE parts installed during the production of or validated by General Motors for GM vehicles. Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE). ⚠ WARNING: Cancer and Reproductive Harm - https://www.P65Warnings.ca.gov
Features and Benefits:
- GM Engineers design and validate OE parts specifically for your Chevrolet, Buick, GMC, or Cadillac vehicle
- GM Genuine Parts are designed, engineered and tested to rigorous standards, and are backed by General Motors
- GM regularly updates production and service part designs to integrate new materials and technologies
- Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE)
Specifications:
End 1 Flare Type:
Inverted
End 1 Thread Diameter:
0.562 in.
End 1 Thread Diameter:
14.287 mm
End 2 Flare Type:
Inverted
End 2 Thread Diameter:
0.5 in.
End 2 Thread Diameter:
12.7 mm
Fitting Finish:
Zinc Chromate
Fitting Type:
Threaded Male
Inside Diameter:
0.193 in.
Outside Diameter:
0.25 in.
Outside Diameter:
6.35 mm
Polyvinyl Fluoride Coated:
No
Features and Benefits:
- – Calipers and wheel cylinders should be checked every brake inspection and serviced or replaced as required.
- – Check brake fluid level at every oil change. Replace fluid according to owner's manual recommendations.
- – Check the thickness of your brake pads.
- – Inspect the brake lines for rust, punctures, or visible leaks (You may be able to do this, but consult a qualified technician if necessary).
- – Inspection of brake lining and pads for wear or contamination by brake fluid or grease.
- – Inspection of the brake hoses for brittleness or cracking.
- – Inspection of wheel bearings and grease seals.
- – Parking brake adjustments (as needed).
- The following inspections and maintenance procedures can help prevent potential brake problems.
- The following should be conducted by a qualified technician:
Specifications:
